Myalarm V-LCD1 Bedienerhandbuch PDF herunterladen (Seite 101)

LCD PROGRAMMING - ADD/CHANGE KEYPAD CODES

8-95

System 2 Installation / Programming Manual

Assign These Output(s) þþþþ

Outputs [ - - - - ]

Option Not Active! þþþþ

Press Any Key

Note: Although the display states the Option is Not Active, the output(s) have been assigned to the selected schedule.

However, it will not activate until the Second Door has been turned ON. Proceed to Option #13 to turn this Option ON.

The unit assigns this output to the user codes for those customers who wish to upgrade a one-door system (2003) to a two-

door system (2016) in the future, but do not wish to re-program the outputs.

Additional Outputs

When a valid code is entered, the door relay for that Port will, by default, be activated. In

addition to this activation of the door relay, you might want other outputs to be activated as well

to, for example, sound an alarm, trip a dialer, or send some other signal. There are four such

outputs from which to choose. The Program Aux Outputs section of this manual details the

physical properties of the outputs. Any, all, or none of these outputs may be triggered by a user,

if the Second Door has been activated. Refer to Option #13 if you need to activate this

option.

The LCD will scroll the instructions:

Scrolling Options: to User ID

1=Aux Relay 1

2=Aux Relay 2

3=Voltage Output 1

4=Voltage Output 2

0=None

At the Outputs [ - - - - ] prompt, enter the desired output(s), if any, then press #.

Example: If you are programming the code 12345 and select Outputs 1 and 3, each time the

code 12345 is used the door will open and Aux Relay 1 and Voltage Output 1 will activate...

provided you have installed a two-door System 2 (2016).

If you are operating the System 2 in its networking mode, outputs triggered by a valid user

operate locally to each unit. In other words, if our valid user who is programmed to trigger

outputs 1 and 3 enters at a door on the master, the master’s outputs 1 and 3 will be triggered. If

this same user enters at a door on Slave #1, outputs 1 and 3 on Slave #1 will be triggered -- and

so on for all other units on the network.

If you select any of these Outputs and you have not activated the Second Door the LCD will

scroll:

Scrolling Options: Install in Option 13

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 335 336

Keine Kommentare

Myalarm V-LCD1 Bedienerhandbuch Seite 101