Myalarm V-LCD1 Bedienerhandbuch PDF herunterladen (Seite 262)

100

101

PC/VDT PROGRAMMING - BACKUP-RESTORE

9-256

System 2 Installation / Programming Manual

Backup-Restore (Option #19)

This option lets you backup all data to a disk and then restore it, should the need arise (memory

loss, circuit board replacement, etc.). Corby supports the Windows

Terminal Emulation

program.

Refer to Chapter 9 to configure the terminal emulator.

You must have a PC to use this feature.

The display will look similar to this:

XMODEM Backup-Restore

1=Backup Sys 2

2=Restore to Sys 2

0=Quit

Enter Selection [ 0 ]

At the Enter Selection [0] prompt, make your selection.

Note: When using the backup and restore feature the XMODEM protocol MUST be used.

Backup System 2

This lets you backup all programmed information to a floppy disk or your PC’s hard drive.

After you have selected 1-Backup Sys 2 you will be prompted:

Begin your "Receive Binary File..." from the Transfer menu.

U Select Transfers from the pull-down menu at the top of the screen

U Select Receive Binary File...

U Choose the drive where you wish to backup the information.

If backing up the information to your PC’s hard drive, choose a directory.

U Type the file name.

U Single click on OK.

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 335 336

Kommentare zu diesen Handbüchern

Keine Kommentare

Myalarm V-LCD1 Bedienerhandbuch Seite 262

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Myalarm V-LCD1