Myalarm V-LCD1 Bedienerhandbuch PDF herunterladen (Seite 191)

PC/VDT PROGRAMMING - PORT CONFIGURATION

9-185

System 2 Installation / Programming Manual

Selecting the Input Device(s)

Each System 2 Port can accept a Keypad Input, Card Input, Keypad AND Card Input or

Keypad OR Card Input. In AND mode both a valid Keypad code and a valid Card must be

entered. In OR mode either may be used for access.

If you selected 0=No Cards in Option #4 you will not see this prompt.

Skip to Selecting Relay Type.

You can choose the mode at the following prompt:

Enter 1,2,3 or 4

1=Keypad Only

2=Card Only

3=Card AND Keypad

4=Card OR Keypad

Input Device(s) [1]

At the Input Device(s) [1] prompt choose the desired type.

There are a couple different scenarios you may want to consider:

- If you are going to use a Keypad exclusively at this door, select 1.

- If you are going to use a Card Reader exclusively at this door, select 2.

- If you are going to use a Keypad and Card Reader at this location, select 3.

- If you are going to use either a Keypad or Card Reader at this location, select 4.

If you want to choose card options 2, 3, or 4, and you have not used Main Menu Option 4 to

configure this System to accept a Data Chip or a specific Card type, you cannot continue in this

Sub-Menu.

The System sees and treats Data Chips exactly the same as cards and therefore, a Data Chip is

always considered a card by this System.

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 335 336

Keine Kommentare

Myalarm V-LCD1 Bedienerhandbuch Seite 191