Myalarm V-LCD1 Bedienerhandbuch PDF herunterladen (Seite 201)

PC/VDT PROGRAMMING - ADD/CHANGE KEYPAD CODES

9-195

System 2 Installation / Programming Manual

The VDT will display the instructions:

01 03

Enter Door (0=Done) [__]

The first line of the VDT will display the door(s) this user is allowed to access.

At the Enter Door (0=Done) [ _ _ ] prompt, enter the next door this user is

allowed to access. When you are finished press 0 and ENTER. If you wish to change the door

permission at any time, reenter the number to deny access to a specified door.

Example: If you wish to “take door #3 permission away” from this user, enter door 3 again and

the permission will be denied.

If you select Port #3 or greater and you do not have this System set-up for networking, the

VDT will display:

Error!

Entry Out of Range!

Press Any Key

To enable more than two doors, the Networking Option needs to be installed. Proceed to

Option #13 for installation instructions.

When you are finished entering door numbers press 0.

User Codes

If, and only if, you have selected keypads as your input device (back in options 4 and 5), you

will be prompted to enter a Keypad code of nine digits or less. User can have varying code

lengths. One user can have a five digit code, another a six digit code, and yet another a three

digit code.

The System ignores any leading zeros. In other words, you cannot program a code of

02306. The System ignores the first zero and the user will only have a four digit code of

2306. As you can see zeros can be used within a code.

At this point, the VDT will display the following instructions:

Enter Keypad Code

Up to 9 Digits

No Leading Zeros

0=Quit

Enter Code [_________]

If you were successful in entering your code, proceed to Entering Additional Outputs.

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 335 336

Keine Kommentare

Myalarm V-LCD1 Bedienerhandbuch Seite 201