Myalarm V-LCD1 Bedienerhandbuch PDF herunterladen (Seite 266)

WINDOWS PROGRAMMING & MODEM SETUP

10-260

System 2 Installation / Programming Manual

Windows 3.1

Starting Windows from a DOS prompt

U Type C:\WINDOWS <enter>

U Type WIN <enter>

U Double click on the ACCESSORIES icon.

U Double click on the TERMINAL icon.

U Single click on the up triangle in the upper right corner to maximize the screen.

Setting up the Terminal Emulator

Each step below requires a single click on the left mouse button, unless otherwise noted.

U SETTINGS

U TERMINAL EMULATION

U DEC VT 100 button

U OK

U SETTINGS

U COMMUNICATIONS

U In the CONNECTOR box select the COM port you have the System 2 connected.

U In the Baud Rate box click on 9600.

U Choose 8 data bits in the DATA BITS box.

U Click on 1 in the STOP BITS box.

U Select NONE in the PARITY box.

U Set the FLOW CONTROL to HARDWIRE.

U OK (Saves your settings)

U FILE

U SAVE

U Type SYSTEM2 <enter>

Loading your settings

U Single click on FILE.

U Single click on OPEN.

U Double click on SYSTEM2

After setting or loading your System 2 terminal parameters, you are ready to program the System

2 panel. Now type your secret number.

If the screen does not display System 2 menus and prompts at this point, make certain:

The connector is plugged into the proper COM port.

The baud rate is set the same in the System 2 as in the terminal settings.

Note: The mouse can not be used to select System 2 programming options. The cursor for

System 2 will be displayed as a blinking block. The terminal emulation program has a thin line

cursor which can be used to arrow up to review previously displayed menus.

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 335 336

Keine Kommentare

Myalarm V-LCD1 Bedienerhandbuch Seite 266