Myalarm V-LCD1 Bedienerhandbuch PDF herunterladen (Seite 92)

LCD PROGRAMMING - AUXILIARY OUTPUTS

8-86

System 2 Installation / Programming Manual

Enter Aux Output þþþþ

Output [ 1 ]

1=Latching, 2=Momentary

Output Mode [ 2 ]

Program Aux Outputs (Option #6)

A two-door System 2 provides four general-purpose auxiliary outputs. Two of these outputs

are

C Form Auxiliary Relays, and two are voltage outputs. The Voltage Outputs are open-collector

transistors. This means that, when activated, the transistors create a “short” between their

terminal connection and System negative. The maximum current that can pass through the

Voltage Output’s transistors is 50mA.

If the Second Door was activated, any of these four outputs can be programmed to be activated

by a valid code entry, as we will discuss in Enrolling Single Users. In addition, they can be

activated from any of the time schedules or from a System event.

Selecting the Output

The LCD will scroll the instructions:

Scrolling Options: 1=Aux Relay 1

2=Aux Relay 2

3=Voltage Output 1

4=Voltage Output 2

At the Output [ 1 ] prompt, enter your selection followed by # (enter).

Output Mode

An output may be triggered by a valid code or other events which we will get to later. How it

will be triggered is what we are interested in here.

The are two modes of output activation: Momentary and Latching. In Momentary mode, the

output is activated for a programmed period of from 1 to 255 seconds. In Latching mode, the

output toggles its state. In other words, if the output is on, it turns off. Likewise, if the output

is off, it turns on.

The LCD will scroll the instructions:

At the Output Mode [ 2 ] prompt, pick the desired option followed by # (enter). If you select

Latching, you are finished, you do not need to enter a Latching Time.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 335 336

Keine Kommentare

Myalarm V-LCD1 Bedienerhandbuch Seite 92